Konica Minolta 7013 psc 用户手册

TCP/IP Configuration-10

You may provide the IP address and other IP parameters to the printer Print Server 
Card on 32 Bit TCP/IP Stack (Windows NT & Windows 95/98) using the 
BOOTPL32.exe program. 

This program uses the BOOTP protocol. The Print Server Card must be on the same 
network segment as the workstation that you are using to configure it. The TCP/IP 
stack must be installed and operating.

The NT cannot be operating as an active DHCP Server.

1. Reset the Print Server Card. 

Note:

The Print Server Card issues the BOOTP request for a finite period of time. The 

print server must be freshly reset for this program to work.

2. From Windows Program Manager under File, select Run BOOTPL32.exe.

3. Pull down the Admin menu to Configure option.

4. Enter the IP address that you want to assign to the Print Server Card, its Subnet 

Mask (make sure it matches what you are using on your subnet), Default Gateway 

(your router's IP address), and the MAC address of the Print Server Card (Hard-

ware Address, listed on the Status sheet as Ethernet Address). Use colons as 

delimiters as shown on the status sheet rather than the dashes Windows uses.

5. Click on Go.

6. Wait about five minutes. The Print Server Card should recycle and produce a sta-

tus sheet showing the IP parameters you have just entered. 

7. Pull down Admin menu to Verify. You should get a message back stating that the 

Unit is Active. If you do not get this message, check that TCP/IP is enabled on the 

status sheet

8. When you get a response that your unit is active, you should be able to ping and 

Telnet to the Print Server Card.

The Print Server Card provides for a setup connection via the standard Telnet port. To 
be able to make changes to a unit at factory default settings, you must logon as 
sysadm.  The default password is also "sysadm" (this password can be changed from 
the Telnet utility). The use of the Telnet utility is described elsewhere.