Konica Minolta dynax maxxum 800si 用户手册
91
REAR-FLASH SYNC
90
This function enables you to bias the output of the built-in flash or
an accessory flash as much as + or – 3 EVs in .5 increments.
an accessory flash as much as + or – 3 EVs in .5 increments.
While pressing the flash-
compensation button, turn
either control dial.
compensation button, turn
either control dial.
When the desired
compensation factor appears
in the viewfinder and data
panel, release the button.
compensation factor appears
in the viewfinder and data
panel, release the button.
MEMORY: The Flash Compensation setting can be stored in
memory. See page 99 for information.
memory. See page 99 for information.
•
will remain in the viewfinder and data panel.
• Flash compensation does not operate with flash units connected to the
PC terminal.
✎
Check the compensation amount by pressing the flash-compensation
button.
button.
✎
Cancel flash compensation by resetting it to 0.0.
FLASH COMPENSATION
Press the shutter-release button partway down to enter
the selection.
the selection.
Press the shutter release button all-the-way down to take
the picture.
the picture.
• Select a shutter speed of 1/90 or slower. If a faster shutter speed is
selected,
will remain in the viewfinder, but a normal exposure will
be made.
• Rear flash sync is not compatible with flash units that have a very long
firing duration. An incomplete exposure will occur.
Turn either dial to display
in the data panel.
2152EE 17/10/97 10:58 AM Page 90