Konica Minolta 7415 ev1 用户手册
3-4
Maki
ng Co
pies
Chap
te
r 3
2. Setting the Original Document
With the Automatic Document Feeder, originals placed into the Document Feed Tray are fed in one sheet
at a time, copied, then fed out. Please follow the instructions provided when using this device. Failure to
follow these instructions may cause a misfeed, damage to the original or other complications.
at a time, copied, then fed out. Please follow the instructions provided when using this device. Failure to
follow these instructions may cause a misfeed, damage to the original or other complications.
◆ Originals should follow these standards
Type of Paper: Plain paper(50–110 g/m
2
)
Paper Size:
A4R–A5R
◆ Originals that are not compatible with the Automatic Document Feeder
• Typing paper, paraffin paper and other thin paper types.
• Thick paper.
• Sizes that are larger than A4 or smaller than A5.
• OHP transparencies, tracing paper or other transparent paper types.
• Wrinkled, folded, curled or torn originals.
• Originals that are stapled or are attached with paper clips.
• Carbon paper or paper with coated surfaces.
* To produce copies from an original document described above, place it on the Original Glass.
• Thick paper.
• Sizes that are larger than A4 or smaller than A5.
• OHP transparencies, tracing paper or other transparent paper types.
• Wrinkled, folded, curled or torn originals.
• Originals that are stapled or are attached with paper clips.
• Carbon paper or paper with coated surfaces.
* To produce copies from an original document described above, place it on the Original Glass.
When using the Automatic Document Feeder
Adjust the Document Guide Plates to the
size of the document.
size of the document.
Set the document so that the side that you
wish to copy is facing up.
wish to copy is facing up.
NOTES
• The maximum number of originals that can be
loaded is 50.
• Make sure that the top of the stack does not
exceed the
mark.
• Be sure to place the original document as
shown in the illustration (step 2).
• Adjust the Document Guide Plates so that they
make contact with the sides of the stack. The
stack may not feed properly if the Document
Guide Plates do not secure the stack in place.
stack may not feed properly if the Document
Guide Plates do not secure the stack in place.
How to set originals
1
C4007O103CA
2
C4007O102CA