National Instruments 3.22E+04 用户手册

When the Device Manager indicates a conflict with another device, you can 
usually correct the problem by manually selecting conflict-free resources. 
To do so, complete the following steps:

1.

Select Start»Settings»Control Panel and double-click on the 
System icon.

2.

Click on the Device Manager tab and click on the View devices by 
type button.

3.

Double-click on the Multi-function adapters icon.

4.

From the Multi-function adapters list, double-click on the serial 
interface that you want to change.

5.

Click on the Resources tab.

6.

Uncheck the Use automatic settings checkbox and click on the 
Change Setting button. If the system does not allow you to change the 
settings, select the configuration that gives you a conflict-free base 
address and interrupt level from the Setting based on list box.

7.

Click on the OK button to save your changes.

This section lists possible error messages returned by the diagnostic utility, 
along with solutions.

If the 

 error message 

appears, complete the following steps:

1.

Verify the hardware resources, as follows:

a.

In the Device Manager tab, under Multi-function adapters, 
double-click on a serial board.

b.

If a serial board is missing from the Multi-function adapters list, 
reinstall the hardware and software. For instructions on how to do 
so, refer to Chapter 2, 

c.

Click on the Resources tab. If the resources were assigned 
properly, the Resources tab shows which resources are assigned 
to your serial ports.

d.

Check the hardware resources. If they are in conflict, refer to the 
previous section, Selecting Conflict-Free Resources.