National Instruments 3.22E+04 用户手册

© National Instruments Corporation

installation

getting started, 1-2
PCI serial board installation (figure), 2-4
serial hardware, 2-3
serial software, 2-1
verification, 2-1
verifying hardware installation, 2-5

introduction, 1-1
isolated four-port boards, D-2
isolated two-port boards, D-1

maximum supported baud rate, C-7
modular jack connector, 2-9

National Instruments Web support, E-1
NI Developer Zone, E-1
NI-Serial setup screen (figure), 2-2

optional equipment, 1-2
overview of serial hardware, 1-2
overview of serial software, 1-4

parity, 3-3
PCI serial board installation (figure), 2-4
PCI-232, 1-2
PCI-485, 1-2, 2-15

setting transceiver control mode, 4-3
transceiver mode control bytes 

two-wire mode: DTR controlled, 4-2
two-wire mode: DTR with Echo, 4-2
two-wire mode: TXRDY auto 

pin descriptions

DB-25

DB-9