National Instruments 3.x 用户手册

© National Instruments Corporation

Always grasp the cable by the connector you are inserting or removing. 

Never pull directly on the I/O cable to unplug it from the PCMCIA device.

3.

Attach the I/O cable. Be careful not to put strain on the I/O cable when 
inserting or removing the cable connector. 

Follow proper ESD precautions to ensure you are grounded before installing the 

hardware.

The NI USB devices support hot insertion on a PDA device, which means 
you can install and remove the NI USB device without rebooting the PDA 
device. You can install an NI USB device into any USB port that supports 
USB host controller capabilities.

1.

Connect the USB adapter cable to the synchronization port on 
the PDA.

2.

Connect the USB device to the adapter cable with the USB cable.

If you are using the USB device on a computer with Windows 2000/XP/Vista and 

NI-DAQmx 7.5 or later installed on it, make sure the correct firmware is installed on the 
device. Go to 

ni.com/info

 and enter code 

USBFirmware

 for more information.

Before connecting a USB device to a PDA for the first time, you must connect the 

USB device to a computer with NI-DAQmx Base 3.x installed on it in order to install the 
appropriate firmware on the USB device. Go to 

ni.com/info

 and enter code 

USBFirmware

 for more information.

1

USB Cable

2

USB Adapter Cable

3

Synchronization Port

1

2

3