briggs--stratton 313574 用户手册

Instruction Sheet

Kit # 313574

NG/LPG Fuel Conversion Kit

NG to LPG Conversion

Each generator system is delivered with a kit that includes the

plug and jet required to convert the engine to use LPG fuel. The

special insertion tool (#19618) is available through Briggs &

Stratton.
NOTICE Only qualified personnel as specified in the product

installation manual should attempt Natural Gas (NG) to

Liquid Petroleum Gas (LPG) conversions. Installations

and conversions must strictly comply with all applicable

codes, industrial standards and regulations. Proper tools

and workmanship are required. Damage resulting from

unauthorized personel will void manuafacturer’s warranty.
NOTICE Ensure that the fuel supply can deliver an engine inlet

pressure of 11 to 14 inches water column.

To Reconfigure for LP:

The generator is equipped with a removable roof and removable

side panels to permit simple servicing.
1. Open control panel door by inserting key into lock and turn

one quarter turn counterclockwise.

  2.  Set generator’s circuit breaker to OFF position.
  3.  Set control panel system switch to OFF.
  4.  Remove 15 Amp fuse from control panel.
  5.  Press roof latch down until roof pops up slightly.

6. Lift roof up a little ways and slide back. Lift roof off of

generator.

7. Rotate 4 knobs 1/4 turn and lift divider off.

8. Lift latches up on both sides of panel to release.

  9.  Pull panel upward and out of grooves.
10.  Repeat steps 8 & 9 to remove other side panel.
11.  Remove 6 screws from exhaust panel.

12. Pull exhaust panel up and out of base.
13. Remove two screws and pull muffler cover off.

NOT

FOR

REPRODUCTION