Navman 5605 用户手册

TRACKER 5505/5505i/5605 Installation and Operation Manual

54

NAVMAN 

Requires a panel for mounting the bracket. 
Ensure that the panel is not likely to deform 
and is not subject to excessive vibration. The 
bracket can be tilted and rotated. The display 
unit can be removed when it is not in use.
1   Hold the bracket in place and mark the 

screw holes.

2  Drill the screw holes and screw the bracket 

in place. Do not overtighten the screws or 
the display unit might not rotate. 

3  Hold the display unit in place on the 

mounting bracket shaft. Hand tighten the 
knob on the mounting bracket. 

Select a position for the display unit:

• 

At least 4” (100 mm) away from the 
compass, at least 12” (300 mm) away from 
any radio transmitter and at least 4 ft (1.2 
m) away from any antenna.

• 

Easy to read and operate. If possible, mount 
the display unit in front of the navigator or 
to the right of the navigator because the 
LCD display is more readable from these 
positions. 

• 

Not exposed to the direct sun or water and 
protected from physical damage during 
rough sea passages.

• 

Easy to access the 12/24 V DC power source 
and convenient to route the transducer 
cables.

There are two mounting arrangements:

Requires a solid panel with access behind 
for wiring and mounting screws. After flush 
mounting, the display unit cannot be tilted 
or moved after installation to reduce any 
unwanted glare or reflections. Carefully select 
the best viewing position before installation. 
This would generally be in a shaded area.
1  Cut a hole in the bulkhead for the display 

unit using the flush mount template.

2  Drill four holes for the mounting studs 

using the flush mount template.

3  Screw the four studs into the brass inserts 

in the back of the display unit.

4  Sit the display unit in place and fit the 

washers and nuts to the studs.

For the TRACKER, with the internal GPS 
antenna:

 

The display unit must have a good view 
of the sky and horizon. The view should 
not be blocked by large parts of the 
superstructure. 

 

The unit can be under glass, perspex, 
fibreglass or fabric, but not under metal or 
wood.

 

Do not mount the unit within 3 m (10 ft) of 
a radio transmitter antenna or within 0.5m 
(20 in) of the plane of a radar antenna.   

Knob

Mounting  
bracket

www.Busse-Yachtshop.de      email: info@busse-yachtshop.de