FMI ccl3018pta-nta 用户手册
www.fmiproducts.com
124971-01C
16
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
Dual Burner Biltmore Split Oak Models
CCL3018PTA/NTA, CCL3924PTA/NTA
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
1. Place front log (#1) on grate fingers. Make
1. Place front log (#1) on grate fingers. Make
sure front log rests firmly between grate
fingers and grate base (see Figure 17).
2. Place base of middle log (#2) in U-shaped
slots of grate base. Cutout on right of
INSTALLATION
Continued
Figure 18 - Installing Middle Log #2
(CCL3924PTA/NTA Shown)
Figure 19 - Installing Rear Log #3
(CCL3924PTA/NTA Shown)
Middle
Log (#2)
Tab
Burner
U-Shaped Slot
Hole in
Grate Base
Pins
Burner
Rear
Log (#3)
Figure 17 - Installing Front Log #1
(CCL3924PTA/NTA Shown)
Front
Log (#1)
Grate
Fingers
Grate
Base
4. Locate holes on bottom of crossover log (#4).
Slide front hole onto left pin (CCL3924PTA/
NTA) or middle pin (CCL3018PTA/NTA) on
middle log (#2) and pin on back log (#3).
See Figure 20 on page 17, for placement.
5.
For CCL3924PTA/NTA Only: Locate pin
and hole on bottom of crossover log (#5).
Slide pin into hole located in crossover log
(#4). Slide hole onto pin on front log (#1).
See Figure 21 on page 17.
middle log should fit over burner (see
Figure 18). Make sure front of middle log
is resting on tabs of grate base.
3. Locate pins on bottom of back log (#3).
Slide these pins into holes in grate base
behind burner (see Figure 19).