National Instruments SCC-TC02 用户手册

© National Instruments Corporation

❑

Documentation

–

One of the following:

•

•

–

–

–

❑

Tools

–

1/8 in. flathead screwdriver

–

Numbers 1 and 2 Phillips screwdrivers

–

Wire insulation strippers

You can download needed documents from 

ni.com/manuals

.

Software scaling of measurements is not supported on the Macintosh operating 

system. Refer to the 

 section for more information about 

measurement scaling.

For general SCC module installation and signal connection information, and 

information about the SC-2345 or SC-2350 carriers, refer to the SCC Quick Start Guide.

Refer to the Read Me First: Safety and Radio-Frequency Interference document 

before removing equipment covers or connecting/disconnecting any signal wires.

You can plug the SCC-TC0X into any analog input socket on the SCC 
carrier. The socket you select determines which E/M Series DAQ device 
channels receive the SCC-TC0X signals.

For single-stage input conditioning, plug the SCC-TC0X into any socket 
J(X +1), where X is 0 to 7, and connect the input signals to the module as 
described in the 

 section.

If you use the SCC-TC0X in a dual-stage configuration, the SCC-TC0X 
must be the first-stage module. Plug it into any socket J(X+9) and plug the 
second-stage SCC into socket J(X+1), where X is 0 to 7. Connect the input 
signals to SCC-TC0X as described in the 

section. The SC-2345 connects the output signals of the first-stage SCC to