brocade-communications-sy rfs6000 用户手册
18
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
How to use this guide
Notes, cautions, and warnings
The following notices and statements are used in this manual. They are listed below in order of
increasing severity of potential hazards.
increasing severity of potential hazards.
NOTE
A note provides a tip, guidance or advice, emphasizes important information, or provides a
reference to related information.
A note provides a tip, guidance or advice, emphasizes important information, or provides a
reference to related information.
CAUTION
A Caution statement alerts you to situations that can be potentially hazardous to you or cause
damage to hardware, firmware, software, or data.
A Caution statement alerts you to situations that can be potentially hazardous to you or cause
damage to hardware, firmware, software, or data.
DANGER
A Danger statement indicates conditions or situations that can be potentially lethal or extremely
hazardous to you. Safety labels are also attached directly to products to warn of these conditions
or situations.
hazardous to you. Safety labels are also attached directly to products to warn of these conditions
or situations.
Notice to the reader
This document may contain references to the trademarks of the following corporations. These
trademarks are the properties of their respective companies and corporations.
trademarks are the properties of their respective companies and corporations.
{ }
Any command/keyword/variable or a combination of them inside a ‘{‘ &
‘}’ pair is optional. All optional commands follow the same conventions
as listed above. However they are displayed italicized.
For example, the command
‘}’ pair is optional. All optional commands follow the same conventions
as listed above. However they are displayed italicized.
For example, the command
RFController> show autoinstall ....
is documented as
show autoinstall
{status}
Here:
•
show autostatus– The command. This command can also be used
as
show autostatus
as
show autostatus
•
{status} – The optional keyword status. The command can also be
extended as
show autoinstall status
extended as
show autoinstall status
Here the keyword status is optional.
<values>
Values to be entered as shown in Blue.
For example, the command
For example, the command
RFController>show wlan 1
is documented as
show wlan <idx>
This command’s parameter <idx> is described as under:
“<idx> – <idx> (1-256) is the Wlan Index.”
“<idx> – <idx> (1-256) is the Wlan Index.”