brocade-communications-sy rfs6000 用户手册
524
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
DHCP Config commands
17
host
Defines a fixed IP address for the host in dotted decimal format
Use the
no host
command to remove the host from the DHCP pool.
Supported in the following platforms:
•
Mobility RFS4000 Controller
•
Mobility RFS6000 Controller
•
Mobility RFS7000 Controller
Syntax
host <IP>
Parameters
Usage Guidelines
The DHCP host pool (used to manually assign an IP address based on hardware address/client
identifier) configuration must contain a host IP address, client name and hardware address/client
identifier.
identifier) configuration must contain a host IP address, client name and hardware address/client
identifier.
The host IP address must belong to a subnet on the controller. There must be a DHCP network pool
corresponding to that host IP address. There is no limit to the number of manual bindings.
However, you can configure only one manual binding per host pool.
corresponding to that host IP address. There is no limit to the number of manual bindings.
However, you can configure only one manual binding per host pool.
Example
RFController(config-dhcp)#host 2.2.2.111
RFController(config-dhcp)#
host <IP>
Sets a fixed address for the host
•
<IP > – Sets an IP address in dotted decimal
format
format