Konica Minolta fs-505 um 1-1-0 用户手册
Copy operations
2
Finisher FS-505
2-13
Punching holes in copies (Punch settings)
!
Detail
In order for holes to be punched in the copies, all of the following
conditions must be met.
conditions must be met.
The paper width must be between 148 mm and 314mm.
The paper length must be between 210 mm and 420 mm.
If a Punch setting is to be selected, select the orientation in which the
document is positioned. If an Original Direction setting is not selected,
holes may not be punched in the copies as desired.
document is positioned. If an Original Direction setting is not selected,
holes may not be punched in the copies as desired.
For details on specifying the document orientation, refer to Copy
Operations of the user manual.
Operations of the user manual.
If a Punch setting is selected, specify the position of the binding margin
and the loading orientation for the original, otherwise the holes will not be
punched as desired.
and the loading orientation for the original, otherwise the holes will not be
punched as desired.
For details on specifying the loading orientation for the original, refer to
Copy Operations of the user manual. For details on specifying the
position of the binding margin for the original, refer to Copy Operations
of the user manual.
Copy Operations of the user manual. For details on specifying the
position of the binding margin for the original, refer to Copy Operations
of the user manual.
2
Note
The number of punched holes differs depending on the country (region)
where the unit is installed. For details, consult your technical
representative.
where the unit is installed. For details, consult your technical
representative.
The number of holes that can be punched differs depending on the type
of punch kit installed. If different hole punch settings are available, select
the setting for the desired use.
of punch kit installed. If different hole punch settings are available, select
the setting for the desired use.