Konica Minolta 7145i gev2 用户手册
Erasing Outside of the Original (Non-Image Area Erase) (continued)
9-28
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select magnification and paper size, as desired.
• APS and AMS are automatically released.
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
store mode will function automatically.
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
DO NOT CLOSE THE DOCUMENT FEEDER.
Original size should be larger than 10 mm x 10 mm.
Original size should be larger than 10 mm x 10 mm.
7.
Press [START].
Oblique Erase and Rectangle Erase Modes
The Non-image area erase has two modes; Rectangle erase mode and
Oblique erase mode. The copier is initially set to Oblique erase mode.
If copy result is not satisfactory in the initial setting, ask Key Operator to
select the Rectangle erase mode, or to specify the original density level to
obtain the optimum copy effect. See p. 13-14.
Oblique erase mode. The copier is initially set to Oblique erase mode.
If copy result is not satisfactory in the initial setting, ask Key Operator to
select the Rectangle erase mode, or to specify the original density level to
obtain the optimum copy effect. See p. 13-14.
This function may perform incorrectly if the lighting is directly over the platen
glass. In this case, consult your service representative about an appropriate
place for installation.
glass. In this case, consult your service representative about an appropriate
place for installation.
Rectangle erase mode
Oblique erase mode