Dacor IF42DBOL 用户手册

下载
页码 6
PLANNING
GUIDE
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
11.14
42” and 48” Wide
Built-In Refrigerators
EF42DBSS, EF42NBSS, EF48DBSS, EF48NBSS, 
IF42DBOL, IF42NBOL, IF48DBOL, IF48NBOL
1/6
O
pening
 D
imensiOns
To avoid tipping during use, the solid soffit must be within 1” 
(2.5 cm) maximum above the refrigerator. If the solid soffit 
is higher than 1” (2.5 cm) or one is not available, then the 
refrigerator must be braced. 
 
If the anti-tip boards are needed, they must be attached to the 
rear wall studs 80” to 90” (203 cm to 229 cm) above the floor. 
See installation instructions for more information. 
 
NOTE: A clearance of ¹⁄
2
” (1.3 cm) must be maintained above 
the top grille in order for the top grille to be removed.
4"
(10.2 cm)
83
¹/
2
" (212.1 cm) min.
84
³/
4
" (215 cm) max.
to bottom of solid soffit
24"
(60.96 cm) min. 
77"
(196 cm)
A
Width
(see chart following)
Revised
04/22/08
"
(1.3 cm)
1
/
2
Model Series
Cutout Width A
EF42, IF42
41½” (105.4 cm) to 41¾” (106.1 cm)
EF48, IF48
47½” (120.7 cm) to 47¾” (121.3 cm)
NOTE: Flooring under refrigerator must be at same level as the 
room. Face of cabinetry must be plumb.
A grounded 3 prong electrical outlet should be placed within 
4” (10.2 cm) of the right side cabinets or end panel. See 
Electrical Requirements for more information.
The water shutoff should be located in the base cabinet on 
either side of the refrigerator or some other easily accessible 
area. If the water shutoff valve is not in the cabinets, the 
plumbing for the water line can come through the floor or 
the back wall. See Water Supply Requirements for more 
information.
See Page 11.15