Directed Electronics clifford 320.3x 用户手册

26

© 2009 Directed Electronics. All rights reserved.

Out of Range

Each time a command is performed the Responder LE will expect a 
command confirmation from the system. If a command confirmation 
is not received the 

and transmit LED’s flash and a long fault tone 

plays as an alert.

No Remote Output

Occasionally when a command is performed the remote may not 
generate a command confirmation output or out of range output. This 
indicates that the system received the command but it was an incom-
plete command (e.g. aux button pressed too short to activate the trunk 
release) or it was an illegal message (e.g. the command was cor-
rupted due to local RF interference). These are temporary normal func-
tions of the system and remote, perform the command again within 10 
seconds to return to normal operation.

Car Select

Car 2

 

must first be turned on (See Remote Control Configuration sec-

tion to turn on). 

Press

1.  

and 

hold the 

button for 3 seconds. The remote flashes 

the transmit LED and beeps once or twice to indicate the selected 
car is 1 or 2.
Release

2. 

 the button for car select or continue to hold for program-

ming. 
Release

3.  

the 

button, then press and release while the transmit 

LED and beeps continue to perform car select. Once the car is 
selected a command can be performed by pressing one of the 
command buttons.

Note: The 1-way remote does not emit any indication beeps. The 
transmit LED flashes once or twice to indicate car one or car two.