cat-eye os1.1 用户手册
Mount
Part Names
Mounting View
5
Main Unit
3
Wire
Fasten the screws
securely
2
Speed Sensor
4
Bracket
Lever
Peel off
Front fork
Caution!:
Insure enough wire clearance in the
area marked with
Insure enough wire clearance in the
area marked with
to allow the
handlebar to fully rotate without pulling
the wire.
the wire.
C
Setup Guide
®
Align the center of the magnet
and the sensor's mark line while ro-
tating the wheel or crank.
and the sensor's mark line while ro-
tating the wheel or crank.
The clearance between the
sensor
sensor
and the magnet
should be less than 10 mm.
1
Magnet
Spoke
Bracket
Wire
Speed sensor
Bracket band
Sensor spacer
Magnet
Nylon tie
Bracket screw (long)
Sensor screw (short)
Lithium battery
(CR2032)
Bracket rubber pad
Wire
Speed sensor
Bracket band
Sensor spacer
Magnet
Nylon tie
Bracket screw (long)
Sensor screw (short)
Lithium battery
(CR2032)
Bracket rubber pad
mark line
Remove
model OS 1.1
U.S. Pat. Nos. 4642606/5904442/Pat. and Design Pat. Pending
Copyright© 2001 CAT EYE Co., Ltd.
OS1.1SE-011025 066600151
1
The position of the sensor and the magnet should be as shown:
Top view
less than 10 mm
Side view
Push
Pull
To remove
E
E
Read me first.
Rubber pad