INSTEON 2456s3 用户手册

2456S3E Rev. 7/18/2012 1:06 PM / See Owner’s Manual for Warranty Information.

Protected under U.S. and foreign patents (see www.insteon.com)

Status

LED

Controlled outlet

Quick Start Guide

ApplianceLinc™ - INSTEON

Plug-In Appliance

On/Off Module

Model: 2456S3

Introduction

Allows you to remotely control any appliance/device in and outside

your home at the touch of a button. Can be used with incandescent

lamps up to 480 Watts and inductive loads up to 15 Amps.

Installing ApplianceLinc

1) Plug appliance/device (also called the load) you want to control into bottom ApplianceLinc outlet

2) Plug ApplianceLinc into unswitched wall outlet

Status LED will turn on

The load will turn on

3) If load does not turn on, turn it on manually using the switch on the load itself

4) Tap Set button to toggle load on and off

You can use the pass-through outlet on the front of ApplianceLinc as a normal uncontrolled wall

outlet. However, do not plug another home automation product into this outlet—stacked modules

may overheat and malfunction.

Make ApplianceLinc a Responder

Control ApplianceLinc from another INSTEON device:

1) Use Set button to adjust ApplianceLinc to desired state (on or off)

2) Put controller into linking mode. (For most controllers press and hold Set button for 3 seconds or an

on/scene button for 10 seconds.)

3) Press and hold ApplianceLinc Set button until it double-beeps

Status LED will flash twice and then turn on solid

4) Confirm link by tapping controller’s button on and off

Connected light/load will turn on and off

Owner’s Manual and Tech Support

For the complete Owner’s Manual and the most up-to-date Quick Start Guide visit

Call: INSTEON Support Line at 800-762-7845

Pass-through outlet

Set

button