Iomega eug 用户手册

Your Jaz drive is a high capacity, high performance removable media
drive which meets the latest Fast SCSI-2 specifications.  With your Jaz
drive you can:

•

Upgrade your existing hard disk.

•

Expand the capacity of your hard drive without limits –
one gigabyte at a time!

•

Edit, run, and store full motion video and digital audio.

•

Back up an entire hard drive on a single 3.5 inch disk.

•

Consolidate all your existing removable media.

•

Run your computer from a Jaz disk.

•

Store and run applications from a Jaz disk.

The performance of your Jaz drive may differ dramatically depending on
the computer, SCSI connection, and operating system with which it is
used.  For maximum performance on a PC, connect your Jaz drive to an
adapter that has Fast SCSI-2 connectors (such as a PCI SCSI adapter) and
use a 32-bit operating system (such as Windows NT or OS/2 Warp).  For
maximum performance on a Macintosh, use a PCI or Nubus SCSI
accelerator card.

Disk Capacity

1GB

Average Seek Time

10 msec (Read)

12 msec (Write)

Average Access Time

15.7 msec

Sustained Transfer Rate

6.6 MB/sec max

5.4 MB/sec avg

3.4 MB/sec min

Rotational Speed

5,394 RPM

MTBF

250,000 hours

Temperature

Operating

10

°

C to 32

°

C (50

°

F to 89

°

F)

Non-operating

-40

°

C to 60

°

C (-40

°

F to 140

°

F)

Relative humidity (non-condensing)

Operating

10% to 80%

Non-operating

10% to 90%

Maximum wet bulb temperature

26.6

°

C (80

°

F)

Altitude

Operating

10,000 feet max.

Voltage

100-240 vac

50/60 Hz

Power dissipation

20 watts input power

(e)Make sure the SCSI chain is properly terminated at each end and that

termination is OFF (or removed) for other devices in the chain.  If your Jaz

drive is the only or last drive on the SCSI connection, make sure the SCSI

termination indicator light on the back of the drive is ON (indicating that

the Jaz drive has termination actually on).  If termination is not on when it

needs to be, move the termination switch on the back of the drive to the

manual ON position ( 

␣).  (Use a pen point or straightened paper clip to

move the switch.)

(f)If your Jaz drive is connected to a SCSI adapter, make sure it is

compatible (see "Non-Iomega SCSI Adapters") and correctly installed in

the computer.  Refer to the documentation that came with the adapter.

(g)

Reinstall your Jaz tools software.

(a)Make sure the Jaz data cable is correctly and completely connected to

both the Jaz drive and a compatible SCSI connection on the computer.

(b)

Check termination on the SCSI chain.  (See the "SCSI Termination

section inside this guide.)

(c)

If an internal device is connected to the same adapter as the Jaz drive,

you may need to remove SCSI terminators from the adapter.  Refer to the

documentation that came with the adapter.

If you are using Jaz on a Macintosh or a PC using Windows/DOS,

Windows 95, or Windows NT, you must either install Tools software on

your system or run the Reclaim utility on the "tools" disk.  (For more

information for Windows/DOS or Windows 95 systems, refer to

 on the Install diskette.)  If you are using the Jaz drive on a

SCSI system where Tools software is not available (such as UNIX), you

must perform a low-level (surface verify) format on the "tools" disk.

(SCSI command 04h)

For additional help on software installation problems under Windows 95,

Windows 3.1, or DOS, refer to 

 on the Windows/DOS

Install diskette.  If you need further assistance, refer to the support

information on the back cover of the Jaz Installation Guide

.

This product carries a one year limited warranty.  For complete warranty

information, refer to the detailed warranty statement shipped with this product.

Printed on recycled paper

© 1997 Iomega Corporation.  Iomega, the Iomega logo and Jaz are registered trademarks of, and the graphic

swirl, hand and eye are trademarks of, Iomega Corporation.  All other product and brand names are the

property of their respective companies.