Link electronic 101-201 用户手册

explanation to configure the AcerRouter 101/201.

Chapter 5 Troubleshooting

This chapter provides the solutions to problems occuring during installation and
operation of the AcerRouter 101/201. Please check the following to solve problems.

Problem & Symptom

Possible cause & Solution

Hardware-

The LAN Tx/Rx LED is off

Modem is not able to dial out

Check all the connections and make sure that they are well connected.

Make sure that your hub/switch is correctly connected to “ Hub” , or your PC to “ Node” .
“ Hub” and “ Node” can not be used at the same time.

Make sure that your Ethernet card is installed properly.

Make sure all the physical connections are well-connected and the Modem is powered
on.

Make sure a working phone line is connected to the Modem.

The number may need to be added with prefix such as “ 0,” to get an outside line. The
comma stands for the connection waiting time.

I Can’ t browse to the IP Gateway Check the TCP/IP setup on your PC.

Run “ winipcfg” under Windows 95/98 prompt DOS or

run “ Ipconfig” under Windows NT prompt DOS. The PC should have an IP address of
192.168.1.x (where “ x” is from 1 to 254.).

If you use fixed IP, you have to set client station IP address in the range of 192.168.1.2
~ 192.168.1.252 except 192.168.1.100 ~ 192.168.1.149, default gateway as
192.168.1.1 and DNS IP as your ISP’ s DNS IP.

If the computer has previously used Dial-up networking for Internet access, you have to
make the following changes:

Click Start, Setting and Control Panels

Double click the Internet icon and then click Connection tab

Select Connection to the internet using a local area network

Click OK to finish.