National Instruments NI 5670 用户手册

© National Instruments Corporation

This section describes the software installation process for NI RF signal 
generators.

You can create applications for NI RF signal generators using 
application development environments (ADE) such as LabVIEW, 
LabWindows

™

/CVI

™

, or other development environments.

Any ADE you intend to use must be installed before you install your driver 
software.

Complete the following steps to install the contents of the NI-RFSG CDs:

1.

Insert the NI-RFSG Disk 1 into the CD drive. The NI-RFSG installer 
should open automatically.

If the installation window does not appear, navigate to the CD drive, double-click 

the drive, and double click 

setup.exe

.

2.

Follow the instructions in the installation prompts to complete the 
NI-RFSG installation. For troubleshooting information, contact NI 
technical support or visit 

ni.com/support

.

Users may see access and security messages during 

installation. Accept the prompts to complete the installation.

3.

When the installer completes, a dialog box appears that asks if you 
want to restart, shut down, or restart later. Select Restart.

Optional add-on software, such as the Modulation Toolkit, extends the 
generation capability of NI RF signal generators for modulation-domain 
and frequency-domain applications. Install any toolkits or add-on software 
you intend to use with the NI RF signal generator after installing the 
NI-RFSG instrument driver.

You must install the NI-RFSG instrument driver before installing the Modulation 

Toolkit add-on software in order to properly install the Modulation Toolkit examples for 
NI-RFSG. If the Modulation Toolkit is already installed, repeat or repair the Modulation 
Toolkit installation after installing NI-RFSG.