Konica Minolta di1610 um 1.0.0 用户手册

When a Message Appears

Di1610

6-21

The copy has dark specks or 
spots.

The copy has lines.

The Original Glass surface is 
dirty.

Wipe the Original Glass 
clean with a soft, dry cloth.

The Original Pad is dirty.

Wipe the Original Pad clean 
with a soft cloth dampened 
with neutral detergent.

The original is highly 
transparent.

Place a blank sheet of paper 
over the original.

The original is 2-sided.

If a thin double-sided 
document is being copied, 
the information on the back 
side may be reproduced in 
the copy. Press the [ ] key 
and select a lighter copy 
density.

Something is sticking to the 
Original Glass (when the 
Auto Document Feeder is 
used).

Wipe the Original Glass 
clean with a soft, dry cloth.

The Drum Cartridge has 
reached the end of its 
service life.

Contact your service 
representative.

The image on the copy is not 
aligned properly.

The original is not placed in 
the correct position.

Place the original correctly 
on the Original Glass against 
the Original Scales.
Or, load it in the Auto 
Document Feeder correctly 
along the Document Guide 
Plates.

The original may not be 
suitable for use in the Auto 
Document Feeder.

Raise the Auto Document 
Feeder and place the original 
on the Original Glass 
correctly against the Original 
Scales.

The Edge Guide and Trailing 
Edge Stop are not pressed 
up against the paper stack in 
the tray.

Slide the Edge Guide and 
Trailing Edge Stop up 
against the edges of the 
paper stack.

The paper has an excessive 
curl.

Smooth out curls in the 
paper and reload the paper 
stack in the tray.

The printed page is curled.

The paper that was used 
curls easily (as with recycled 
paper).

Remove the paper from the 
paper tray, turn it over, and 
then load it again.

Change the paper.

Ö