Konica Minolta di1610 um 1.0.0 用户手册

Introduction

1-6

Di1610

This is a digital machine which operates using a laser. There is no 
possibility of danger from the laser provided the machine is operated 
according to the instructions in this manual.

Since radiation emitted by the laser is completely confined within a 
protective housing, the laser beam cannot escape from the machine 
during any phase of user operation.

This machine is certified as a Class 1 laser product. In other words, the 
machine does not produce hazardous laser radiation.

Maximum Average Radiation Power: 36.903 µW at the laser aperture of 
the print head unit.

Wavelength: 770-800 nm

This product employs a Class 3b laser diode that emits an invisible laser 
beam.

• Do not store toner units, PC drum units, and other supplies and 

consumables in a place subject to direct sunlight and high temperature and 
humidity, as poor image quality and malfunctions could result.

• Do not attempt to replace the toner unit and PC drum unit in a place 

exposed to direct sunlight. If the PC drum is exposed to intense light, poor 
image quality could result.

• Do not unpack a toner unit or PC drum unit until it is to be used. Do not 

leave a unit unpacked. Install it immediately, otherwise poor image quality 
could result.

• Do not keep toner units and PC drum units in an upright position or upside 

down, as poor image quality could result.

• Do not throw or drop a toner unit or PC drum unit as poor image quality 

could result.

• Do not use this product in an area where ammonia or other gases or 

chemicals are present. Failure to do so may shorten the service life of the 
product, cause damage to it or decrease its performance.

• Do not use this product in an environment with a temperature outside the 

range specified in the User Manual, as a breakdown or malfunction could 
result.

• Do not attempt to feed stapled paper, carbon paper or aluminum foil 

through this product, as a malfunction or fire could result.

Do not touch or scratch the surface of the toner unit developing roller and the 
PC drum, as poor image quality could result.

Use the supplies and consumables recommended by the dealer. Use of any 
supply or consumable not recommended could result in poor image quality 
and machine breakdown.