Konica Minolta 7033 ev5 用户手册

v

Start Copying
Press the START PRINT button. Originals loaded on RADF
are all scanned and discharged, then output job starts in
succession.

When using Store mode, press the START PRINT button to
start the output job.

To stop copying, press the STOP/CLEAR button. Scanned
data in the memory will be cleared.

After completion of copying, all the data in the memory will
be cleared.

The memory may be fully loaded to cause overflow during scanning. See p. 12-4 to p.
12-5.

The capacity of the Finisher exit tray is listed below. When the total number of
copies in the copy run exceeds the stated capacity, be sure to unload the exit
tray whilst the copier is still copying. Failure to do so will cause the copier to
jam.
The following capacity is for 80g/m

2

 paper. When copying mixed size originals,

the capacity will be less than the following.
Non-sort mode

Tray 1: 100 sheets/ 10 sheets (thin/thick paper, OHP films, etc.)
Tray 2/3: 500 sheets (A4R, A4, B5R, B5, 8.5"x11"R)

300 sheets (A3, B4, F4/8.5"x13", A5R)

Sort/Group mode

Tray 2/3: 500 sheets (A4R, A4, B5R, B5, 8.5"x11"R)

300 sheets (A3, B4, F4/8.5"x13")

Staple-sort mode

500 sheets max. (A4R, A4, B5R, B5, 8.5"x11"R)
300 sheets max. (A3, B4, F4/8.5"x13", A5R)

In the case of the copier without a finisher, the exit tray capacity is 100 sheets.
Be sure to remove the copies from the exit tray while copying before the
maximum capacity is reached. Failure to do so will cause the copier to jam.

After completion of copying, cancel the selected application function.
•

To release Mixed original mode, display the Application Selection screen, touch “

” key and then touch “

” key.

•

To release all the application functions, display the Application Selection screen and
touch “

” key.

•

To restore the initial copying conditions, press the AUTO RESET button on the Operation
panel.