Konica Minolta 7033 ev5 用户手册

The FS-105 finisher can be used in any of the following five modes in combination with
the RADF.

q

 Non-Sort

: Use Finisher upper exit tray (TRAY 1), middle exit tray (TRAY 2), or

lower exit tray (TRAY 3).
Copies are normally discharged into the specified exit tray.

w

 Sort

: Use Finisher middle exit tray (TRAY 2) or lower exit tray (TRAY 3).

Automatically copies the original set and delivers the complete sets
to the specified exit tray, offset and stacked.

e

 Staple-Sort

: Use Finisher middle exit tray (TRAY 2) or lower exit tray (TRAY 3).

Copies are automatically sorted and stapled.

r

 Group

: Use Finisher middle exit tray (TRAY 2) or lower exit tray (TRAY 3).

Group together multiple copies of each original and offset the sets
upon exit.

r

 Face Up Tray1 : Use Finisher upper exit tray (TRAY 1).

Copies exit to the upper tray in the reverse order, with simplex sheets
and odd numbered duplex sheets face up.

When the amount of copies delivered onto the Finisher exit tray (upper, middle or
lower) exceeds its limit described below, the copier automatically shifts the output to
another tray to complete the output job.

Finisher upper exit tray:
After 100 sheets (irrespective of the paper size) delivery, the output shifts to the
middle, then lower tray.
Finisher middle exit tray:
After 300 sheets (A3, B4 or F4/8.5"x13")/500 sheets (A4R, A4, B5R, B5, A5R,
8.5"x11R or 8.5"x11") delivery, the output shifts to the lower tray.
Finisher lower exit tray:
After 300 sheets (A3, B4 or F4/8.5"x13")/500 sheets (A4R, A4, B5R, B5, A5R,
8.5"x11R or 8.5"x11") delivery, the output shifts to the middle tray.

Release lever

Finisher upper exit tray

Finisher lower exit tray

Finisher middle exit tray

Staple driving portions