Cobra cp9105ml 用户手册
Connect round
connector into
power jack on base.
connector into
power jack on base.
Connect power
adapter in outlet.
adapter in outlet.
Installation
Important Safety Instructions
Quick Set-Up
Guide
Guide
3
2
Quick Set-Up Guide
2
3
continued on next page
Note
The battery must be charged
at least 12 hours before use.
at least 12 hours before use.
Replacement batteries are
available direct from Cobra.
See Accessories section on
page 32.
available direct from Cobra.
See Accessories section on
page 32.
Install Ni-Cad battery in the handset.
To remove the battery door, press and slide
downward.
To remove the battery door, press and slide
downward.
Observe connection orientation, connect the
battery and replace the door. The LOW
BATTERY indicator will blink until the handset
is placed in the base and power is applied to
the base.
battery and replace the door. The LOW
BATTERY indicator will blink until the handset
is placed in the base and power is applied to
the base.
1
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric
shock and injury to persons, including the following:
1 .
shock and injury to persons, including the following:
1 .
Read and understand all instru c t i o n s .
2 .
Follow all warnings and instructions marked on the pro d u c t .
3 .
Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for
c l e a n i n g .
c l e a n i n g .
4 .
Do not locate base unit near water, for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement or
near a swimming pool.
near a swimming pool.
5 .
Do not place this product on an unstable cart, stand or table. The product may fall, causing serious damage to the pro d u c t .
6 .
Slots and openings in the cabinet and the bottom or back are provided for ventilation, to protect it from overheating; these open-
ings must not be blocked or covered. The openings should never be blocked by placing the product in the bed, sofa, rug or other
similar surface. This product should never be placed near or over a radiator or heat re g i s t e r. This product should not be placed
in a built-in installation unless proper ventilation is pro v i d e d .
ings must not be blocked or covered. The openings should never be blocked by placing the product in the bed, sofa, rug or other
similar surface. This product should never be placed near or over a radiator or heat re g i s t e r. This product should not be placed
in a built-in installation unless proper ventilation is pro v i d e d .
7 .
This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the
type of power supply to your home, consult your dealer or local power company.
type of power supply to your home, consult your dealer or local power company.
8 .
Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking
on it.
on it.
9 .
Do not overload outlets and extension cords as this can result in the risk of fire or electric shock.
1 0 .
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out
parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the pro d u c t .
parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the pro d u c t .
11 .
To reduce the risk of electric shock, do not disassemble this product, but take it to qualified servicemen when service or re p a i r
work is re q u i red. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can
cause electric shock when the appliance is subsequently used.
work is re q u i red. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can
cause electric shock when the appliance is subsequently used.
1 2 .
Avoid using telephones (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock fro m
l i g h t n i n g .
l i g h t n i n g .
1 3 .
Do not use the telephone to report a gas leak in the vicinity of the leak.
1 4 .
Unplug this product from the outlet and refer servicing to qualified service personnel under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the pro d u c t .
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covere d
by the operating instructions because improper adjustment of other controls may result in damage and will often re q u i re exten-
sive work by a qualified technician to re s t o re the product to normal operation.
E. If the product has been dropped or the cabinet has been damaged.
F. If the product exhibits a distinct change in performance.
A. When the power supply cord or plug is damaged or frayed.
B. If liquid has been spilled into the pro d u c t .
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covere d
by the operating instructions because improper adjustment of other controls may result in damage and will often re q u i re exten-
sive work by a qualified technician to re s t o re the product to normal operation.
E. If the product has been dropped or the cabinet has been damaged.
F. If the product exhibits a distinct change in performance.
1 5 .
Never install telephone wiring during a lightning storm.
1 6 .
Never install telephone jacks in wet locations unless jack is specifically designed for wet locations.
1 7 .
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
C A U T I O N :
To reduce the risk of fire or injury to persons, read and follow these instructions:
A .
Use only the battery pack supplied with the unit or identical re p l a c e m e n t .
B .
Do not dispose of battery pack in a fire. The cells may explode. Check with local codes for possible disposal instru c t i o n .
C .
Since released electrolyte is corrosive and may cause damage to eyes or skin and may be toxic if swallowed:
C1. Do not open or mutilate battery pack.
C2. Always replace the entire battery pack rather than reusing one or more cells.
C3. Do not expose batteries to heat or flame.
C1. Do not open or mutilate battery pack.
C2. Always replace the entire battery pack rather than reusing one or more cells.
C3. Do not expose batteries to heat or flame.
D .
E x e rcise care in handling the battery pack in order not to “short” the battery contacts with conducting materials such as rings,
bracelets, and keys. The battery or conductor may overheat and cause burns.
bracelets, and keys. The battery or conductor may overheat and cause burns.
Save These Instructions
Important Safety Instructions
(continued)
CAUTION (continued):
E .
C h a rge the battery provided with or identified for use with this product only in accordance with the instructions and lim-
itations specified in this manual.
itations specified in this manual.
F.
Observe proper polarity orientation between the battery and battery charg e r.
CP9105 manual layout.8 10/14/98 9:27 AM Page 7