winternals erd commander pro 1.03 用户手册
ERD Commander
Version 1.03
Winternals Software LP
Page 21
6
Troubleshooting
When ERD Commander is booting I get an error that a file is corrupt, or that
the boot cannot continue for some reason. What is the problem?
Errors during ERD Commander’s boot process are almost always due to
defective floppy disk media. (This damage will only be detected by
running a low-level sector scan of the disk.) Try creating the boot
diskettes using a new set of floppy diskettes.
Can I run external programs or commands once I've booted with ERD
Commander?
Because ERD Commander runs before the Win32 subsystem begins
executing, it is not possible to run any programs other than those built
into ERD Commander .
How do I install a new driver for hardware ERD Commander doesn't
recognize?
If you have a SCSI disk device that you'd like to access from within ERD
Commander that is not being recognized with the default setup, you can
add a new driver to the boot diskette set as follows:
Copy the new driver to floppy #3. Edit TXTSETUP.SIF from floppy #1,
and add a reference to the driver in the following three sections, copying
the format for existing drivers:
Under the [SourceDisksFiles] heading:
oemdrvr.sys = 1,,,,,,_3,4,1
Under the [SCSI.Load] heading:
oemdrvr = oemdrvr.sys,4
Under the [SCSI] heading:
oemdrvr = "HAL 9000 SCSI Host Adapter"