winternals erd commander pro 1.03 用户手册

ERD Commander 

Winternals Software LP

 

Page 5  

The ERD Commander Setup program will allow you to create a set of Alpha 

NT boot floppies that are configured with ERD Commander. The Setup 

program will also allow you to install the ERD Commander boot files into a 

directory on a hard drive or removable media. Follow your ARC OS loader 

instructions to initiate a boot of ERD Commander, specifying “SETUPLDR” as 

the boot file. Most ARC OS loaders accept the command “A:SETUPLDR” for 

booting off a floppy. 

After the installation has completed you can run the Setup program from the 

ERD Commander program group to create additional sets of diskette sets. 

Portions of Alpha NT boot disk creation copyright BEI, makers of UltraBac 

backup software for Windows NT (http://www.ultrabac.com). 

Some systems have non-standard SCSI disk drives that require third-party 

drivers to function under Windows NT. A set of ERD Commander boot 

diskettes will not prompt you to specify such drivers like the standard 

Windows NT boot diskettes do. However, it is possible to add third-party 

SCSI device drivers to ERD Commander boot diskettes by following the 

procedure outlined below. Note that this is not a supported option, but 

presented here for your convenience.  

Copy the driver(s) to floppy #3 and edit the txtsetup.sif file, which located on 

floppy #1.  Add a line for each driver in the following three sections: 

1.  Under the [SourceDisksFiles] heading: 

2.  Under the [SCSI.Load] heading