Terratec sine di 用户手册
Function
The SINE DI 4 rack system is an active direct injection box that converts unbalanced line
signals to balanced signals. Apply an unbalanced line signal to the input on the front or
rear panel to get a balanced signal at the XLR output. The signal is also fed through un-
changed to the Link-Out socket.
signals to balanced signals. Apply an unbalanced line signal to the input on the front or
rear panel to get a balanced signal at the XLR output. The signal is also fed through un-
changed to the Link-Out socket.
You can also attenuate the signal by –20 dB or –40 dB.
And if you're being annoyed by hum pickup, use the ground lift switch to fully isolate the
input and output signals from one another.
input and output signals from one another.
Note: do not connect two sources (front and back) to the same input channel. This
may damage the device.
may damage the device.
Technical data
Audio inputs:
4 x 1/4" unbalanced jacks, front panel
4 x 1/4" unbalanced jacks, rear panel (parallel to front panel)
4 x 1/4" unbalanced jacks, rear panel (parallel to front panel)
Input impedance:
470 ohm
Audio outputs:
4 x XLR, balanced, rear panel
4 x Link-Out, unbalanced, front panel
4 x Link-Out, unbalanced, front panel
Output impedance:
1 kohm
Frequency response:
25 Hz – 20 kHz
AC power:
12V AC, 700 mA
Dimensions:
482.6 x 87 x 44 mm (19”, 1U)
SINE DI 4 / SINE DI 8 (English)
7