lift-master fire release box 用户手册
Fire Release Box Installation
Gate Chain
Pin
Pin
Chain
Bracket
Steel
Cable
The chain is held in place by s spring loaded pin
1/2" EMT
(Not Included)
1/2" EMT
Connector
(Included)
“T” Handle
1/2" EMT
Connector
(Included)
This “Fire Release Box”, is designed for use
on sliding gates. It consists of a plated box,
with doors on the front and back. The doors
can be locked with your own padlock, or the
fire dept's padlock. The fire box would be fixed
to the gate pickets. It can be opened from
either side of the gate. A steel cable with a
t-handle runs from the box to the release
mechanism at the rear end of the chain. We
do not provide the 1/2" EMT (electrical metallic
tubing) to run the cable through. The release
mechanism is placed where the chain bolt
would normally be. When you pull on the
t-handle, you release the chain. To reconnect
the chain, simply reinsert the pin into the
housing for normal operation.
For Technical Support: 1-800-528-2806
845 Larch Avenue Elmhurst, Illinois 60126
www.chamberlain.com
© 2005 The Chamberlain Group, Inc.
All Rights Reserved
01-50636
®
™