lift-master 67lm 用户手册

 

For use with any Security Plus

™

compatible garage door

opener receiver.
Personalized Code: Up to 10,000 possible combinations.
Code can be easily changed if desired.
Operation: 12 Volt power supply. Opener activates when 4-
digit code and Enter button is pressed.
If wrong numbers are accidentally pressed, correction can be
made immediately. The Enter button will transmit only the last
four digits.
The Keypad will blink for 15 seconds after the code is
transmitted. During that time the Enter button can be used to
stop or reverse the door travel.
A temporary entry code can be added for visitors or service
persons. This temporary code can be limited to a
programmable number of hours or a programmable number
of entries.

To comply with FCC/IC rules, adjustment or modification of receiver and/or
transmitter is prohibited, except for changing the code setting and replacing the
transmitter battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Choose a convenient
location for
installation. It should
be at eye level,
reachable by the
shortest person who
will use it, and within
sight of the door. For
a one-piece door,
choose the optional
location shown in the
illustration to avoid
injury as the door swings out. 

Open the keypad cover and
remove the battery
compartment screw and cover.
Take out the battery.

Hold keypad firmly with the
cover half open so both top and
bottom mounting holes are
visible. Use a punch to mark
each hole. Drill two 1/8" pilot
holes. Fasten securely with
screws provided.

Insert the plug provided into the
top hole to cover the fastening screw. Reinstall the battery,
matching the + and – markings on the battery
compartment. Refasten the compartment cover.

Press the four buttons for the present personal entry code,
then press and hold the 0 button, then press Enter.

The opener light will blink twice. Release the buttons.

Press the new 4-digit code you have chosen, then press
Enter.

The opener light will blink once when the code has been
learned.

Test by pressing the new code, then press Enter. The door
should move.

Door Jamb Edge

(Optional Location 

for 1-Piece Door)

Keypad

Door Jamb Face

SECTIONAL DOOR ONLY

Exterior Front Wall

1-Piece or 

Sectional Door

Clavier

Mur avant extérieur 

Porte rigide ou articulée

Bordure étroite

 du montant de porte

(emplacement en option

pour les portes rigides)

Face du montant

PORTE ARTICULÉE SEULEMENT

1.Choose a 4-digit personal entry code using the numbers

from 0 to 9 (a number can be used more than once, for
example, 4,0, 4,1.)

2. Press the four buttons for the code, then press and 

hold

the Enter button. The indicator light on the door opener
panel will blink.

3. Press and release the “Smart” button on the door

opener panel. After the opener lights blink, release the
Enter button.

Test by pressing the the code, then press Enter. The door
should begin to move.

1.

With the door closed, enter the four digit code desired,
then press and hold Enter.

2. Press and hold the light button on the door control.

3. Press and hold the door control push bar.

4. After the opener lights blink, release all buttons.

Plug

41A4386

Plug

Battery

 Cover

Battery

1

2

ABC

4

GHI

6

MNO

8

TUV

ENTER

0

3

DEF

5

JKL

7

PRS

9

WXY

Indicator

Light

Smart

Button

Témoin

Bouton

SRT

 

1