lift-master 91lmc 用户手册
Garage Door Opener
with "Smart" Button
"Smart"
Button Indicator Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
© 1997, Chamberlain Group Inc.
114A2227
All Rights Reserved
Printed in Mexico
Children operating or playing with a garage door opener
can injure themselves or others. The garage door could
close and cause serious injury or death. Do not allow
children to operate the wall push buttons or remote
controls.
can injure themselves or others. The garage door could
close and cause serious injury or death. Do not allow
children to operate the wall push buttons or remote
controls.
A moving garage door could injure or kill someone under
it. Activate the opener only when you can see the door
clearly, it is free of obstructions, and is properly adjusted.
it. Activate the opener only when you can see the door
clearly, it is free of obstructions, and is properly adjusted.
WARNING
Model 91LMC Security
✚
Single Function Remote Control
OWNER'S MANUAL
Replacement Parts
Model 91LMC Security
✚
remote case, cover, screw . . . . . . . .41A5081
(circuit board not included)
12 Volt battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10A14
Figure 2
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
1-800-654-4736
The 90 Series remote control (with yellow battery test
light) works only with door openers and light controls
having an orange "Smart" button and a yellow indicator
light. The code between the remote control and the
receiver changes with each use, randomly accessing
over 100 billion new codes.
light) works only with door openers and light controls
having an orange "Smart" button and a yellow indicator
light. The code between the remote control and the
receiver changes with each use, randomly accessing
over 100 billion new codes.
Programming instructions are described and illustrated
below.
below.
Security
✚
Garage Door Openers
To program the opener to accept the remote control
code:
code:
1. Press and
hold the remote control push button. See
Figure 1.
2. Press and release the “Smart” button on the opener
panel. See Figure 2. The indicator light on the panel will
begin to blink and the opener lights will
begin to blink and the opener lights will
flash once.
3. Release the remote push button.
Now the opener will operate when that remote control
button is pressed. Test it by pressing the remote button to
see that the door goes up and down.
button is pressed. Test it by pressing the remote button to
see that the door goes up and down.
Adding a remote can also be done from a Multifunction
door control, as follows:
door control, as follows:
1.
With the door closed, press and hold the remote push
button.
button.
2. Press and hold the Light button on the door control.
3. Press and hold the door control push bar.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button.
To erase all remote control codes:
Press and hold the “Smart” button on the opener panel until
the indicator light turns off (about 6 seconds). All transmitter
codes are now erased. Then follow the steps above to
reprogram each remote control.
the indicator light turns off (about 6 seconds). All transmitter
codes are now erased. Then follow the steps above to
reprogram each remote control.
NOTICE: To comply with FCC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Figure 1
Yellow
Battery Indicator
Light
Push button
Model 91LMC
Security
✚
Remote Control