lift-master tcr2 用户手册
Step 1 Power Supply Selection Setting
The TriCode
The TriCode
TM
receiver is factory set for 24 volt power
input if 12 volt is required.
Remove back cover of receiver by removing screws.
Set jumper to the 12 volt setting (Refer to figure 1).
Set jumper to the 12 volt setting (Refer to figure 1).
CAUTION:
To avoid possibility of duplicating
codes in adjacent systems, all transmitters and
receivers should be re-coded prior to operation.
Unless using maximum number of codes the
following four codes should not be used:
· All DIP Switches ON
· All DIP Switches OFF
· DIP Switches alternating ON/OFF
· DIP Switches alternating OFF/ON.
receivers should be re-coded prior to operation.
Unless using maximum number of codes the
following four codes should not be used:
· All DIP Switches ON
· All DIP Switches OFF
· DIP Switches alternating ON/OFF
· DIP Switches alternating OFF/ON.
Receivers should be installed at least 5 feet apart to
avoid cross-talk. After completing installation,
operate transmitter outside of building to make
certain the chosen DIP switch setting does not
operate with nearby garage door operators and/or
security systems. If so, select another DIP switch
setting and check the coded signal again. Repeat as
necessary.
avoid cross-talk. After completing installation,
operate transmitter outside of building to make
certain the chosen DIP switch setting does not
operate with nearby garage door operators and/or
security systems. If so, select another DIP switch
setting and check the coded signal again. Repeat as
necessary.
RECEIVER MOUNTING
Mount receiver to wall using #6 hardware (Not
Supplied). Hardware used will depend on mounting
application. (Refer to figure 1 for receiver mounting
hole locations).
Mount receiver to wall using #6 hardware (Not
Supplied). Hardware used will depend on mounting
application. (Refer to figure 1 for receiver mounting
hole locations).
POWER SWITCH SETTINGS
FIGURE 1
BACK VIEW
2
MOUNTING HOLES