King Technology pool frog above ground mineral system 用户手册
Apply pipe thread tape to
the threaded end of both
hose adapters.
the threaded end of both
hose adapters.
Screw adapters into each end of POOL FROG
®
Cycler. Tighten turning 1 to 2 revolutions with wrench.
DO NOT OVER TIGHTEN.
DO NOT OVER TIGHTEN.
Attach the filter section of
flex hose to one hose
adapter and the return
section of flex hose to the
other hose adapter with
clamps and tighten with
screwdriver.
flex hose to one hose
adapter and the return
section of flex hose to the
other hose adapter with
clamps and tighten with
screwdriver.
Above Ground, Base Installation
HOSE
CLAMP
CLAMP
HOSE
ADAPTER
ADAPTER
HOSE
CLAMP
CLAMP
HOSE
ADAPTER
ADAPTER
TO POOL
1 1/2" OR 1 1/4"
FLEX HOSE
FLEX HOSE
1 1/2"
X
1 1/2"
X
1 1/4"
HOSE ADAPTER
HOSE
CLAMP
CLAMP
FILTER &
PUMP
PUMP
The POOL FROG
®
Cycler should always be
installed between the filter and pool (or between
heater and pool if applicable).
heater and pool if applicable).
TO POOL
PUMP
FILTER
Bi-flow valve design allows
water flow in either direction.
water flow in either direction.
1.
2.
3.
4.
5.
MATERIALS NEEDED
Two
Hose
Clamps
Hose
Clamps
Corrosive Resistant
Check Valve
Check Valve
RECOMMENDED
OPTION
1 1/2" Male Adaptor
(slip
(slip
X
MPT)
When installing with
hard PVC pipe, use a
male adapter on the
inside port threads.
hard PVC pipe, use a
male adapter on the
inside port threads.
#10
X
1 1/4" Phillips
Pan Head Screws with
Washers
Washers
15
TOOLS NEEDED
If using a POOL FROG
®
Bac Pac installing a corrosion resistant
check valve is recommended.
Pipe Thread
Tape
Two Hose Adapters
1 1/2"
1 1/2"
X
1 1/2"
X
1 1/4"
Two Sections
of 1 1/2" Flex Hose
(one provided with filter)
of 1 1/2" Flex Hose
(one provided with filter)
For better stability, POOL
FROG
FROG
®
Cycler may be
mounted on a base using
Phillips pan head screws. One
in front and two in back.
Phillips pan head screws. One
in front and two in back.
Screwdriver
Pipe Wrench