kvh 01027702bk install 用户手册
54-0350
3.9
Installing the Receiver
Connect the Power Cable to the Battery
(Alternative Wiring Option, Only If Necessary)
(Alternative Wiring Option, Only If Necessary)
If you are unable to connect the receiver power cable
to switched (accessory) power as described on the
previous page, you may wire the receiver to battery
power if you follow the minimum requirements
listed below.
to switched (accessory) power as described on the
previous page, you may wire the receiver to battery
power if you follow the minimum requirements
listed below.
•
Install a protective fuse (6 amps) within 18" of the
battery.
battery.
•
Install a relay, switched from the ignition,
between the battery and the receiver.
between the battery and the receiver.
•
Use fire-resistant AWG 8 wire from the relay to
the battery.
the battery.
Ground
Pillar Ground Screw
Fuse
(6 amp)
Vehicle
Battery
Battery
+12 VDC
Ground
Switched
Relay
Ground
Ignition
AWG 8
Wire
+
–
AU T I O N
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
DIGITAL
AUDIO
OUT
TO
110W/HD
CONVERTER
TO KVH
ANTENNA
POWER (10-16V DC)
MAINTENANCE PORTS
USB
RS232
FUSE (8A)
Power Wiring (Alternative Option)
Bus, Limo, and RV Installations
If vehicle power fluctuates or is noisy, KVH
recommends that you use an AC/DC power
supply (KVH P/N 72-0206-01) to provide
stable power to the receiver.
recommends that you use an AC/DC power
supply (KVH P/N 72-0206-01) to provide
stable power to the receiver.