Panasonic SC-ZT2 操作指南

VQT2R71

To return to the previous 
display/To cancel during setting 
operation (➜ page 23): Press 

This function is effective during surround playback only. You can enjoy the dynamic effect 
even if the sound volume level is low during surround playback.

Press [WHISPER-MODE SURROUND] to select “W.S. ON ”.

•  The current setting is displayed first.

Each time you press, the setting switches between “

W.S. OFF ” and “W.S. ON ”.

„

  To cancel        Press [WHISPER-MODE SURROUND] to select “W.S. OFF ”.

•  WHISPER-MODE SURROUND is not effective in the following cases.
 

When not using the surround speakers:

 

    When Dolby Virtual Speaker is off.

 

When using the surround speakers:

 

    When Dolby Pro Logic   and SFC are off with 2-channel signal input.

•  If the above setting is made when this function is on, this function temporarily becomes off.

Enjoy gaming with more dynamic sound.

• “

GAME ” mode (➜ page 19) in SFC is selected.

„

  To cancel        Press again.

  If cancelled, SFC’s effect itself is cancelled.

“

MUTE ” blinks on the display while the volume is muted.

„

Press again.

•  Muting is cancelled when you switch the system to standby.
•  Muting is also cancelled when you adjust the volume.

When you feel the bass volume is not balanced with the volume of the front speakers, you 
can adjust the bass during playback.

1. Press [CH] to select “WFR ”.

(The speaker is switched each time you press the button.)
WFR (woofer) → RS (surround right) (when used) → LS (surround left) (when used)

 Adjustment 

range: 

MIN, 1 to 15, MAX

When using the surround speakers, you can adjust them, too.

1. Press [CH] to select “RS ” or “LS ”.

(The speaker is switched each time you press the button.)
WFR (woofer) → RS (surround right) → LS (surround left)

 Adjustment 

range: 

–10 to +10

„

•  You cannot adjust the front speakers with this operation. To adjust the volume balance 

of left and right front speakers, see “Adjusting the volume balance of front speakers”. 
(

➜ page 23)

•  If the sound is distorted, lower the level.
•  You cannot adjust the output level of speakers if the sound field effect is off and the 

speakers’ audio output is set to off. (➜ page 19)

•  You can adjust the speaker’s output level in SFC’s each mode respectively. (➜ page 19)

•  When a commercially available active subwoofer is connected to the subwoofer output 

terminal on this unit’s rear panel, the subwoofer is synchronized with the unit and the 
sound volume is adjusted.