Panasonic RX-ES29 操作指南
RQT7967
10
Cassette Tape Play
[1] Press [
<
DECK] to open the deck.
(The unit comes on.)
Load a cassette and close the
deck by hand.
A: Side to be played back facing
Load a cassette and close the
deck by hand.
A: Side to be played back facing
up.
B: Insert the cassette with the
exposed tape facing you.
[2] Press [
1TAPE] to start play.
[3] Press [+, – VOLUME] to adjust volume.
* when using AC power.
Cassette Tape Recording
Before Recording
Notes:
≥
Use household AC power or new batteries when recording to
avoid poor recordings caused by the batteries running down.
avoid poor recordings caused by the batteries running down.
≥
Televisions can cause interference to recordings made on
this unit if they are too close to each other.
this unit if they are too close to each other.
Selection of tapes
Use normal position tapes.
High position and metal position tapes can be played, but the
unit will not be able to record or erase correctly.
Use normal position tapes.
High position and metal position tapes can be played, but the
unit will not be able to record or erase correctly.
Volume and sound quality in recording
≥
Recording level is set automatically.
≥
Recordings are unaffected by changes to sound quality.
To display the tape counter while recording
Press [DISPLAY].
Each time you press the button in the CD or radio mode:
Each time you press the button in the CD or radio mode:
To reset the tape counter
Press [C.RESET].
The counter resets to “000”.
Press [C.RESET].
The counter resets to “000”.
Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
recording. To record on the tape again, cover as shown.
A Side A
B Tab for side “B”
C Tab for side “A”
D Adhesive tape
B Tab for side “B”
C Tab for side “A”
D Adhesive tape
To erase recordings
1 Press [
< DECK] to open the deck and insert the cassette
with the side to be erased facing up.
2 Press [
∫ TAPE/CD] to switch to TAPE mode.
3 Press [
¥/;].
Recording CDs
Normal recording
Preparation:
Wind on the leader tape.
Wind on the leader tape.
[1] Press [
< DECK] to open the deck.
[2] Press [
∫ TAPE/CD] to switch to CD mode.
[3] Press [
¥/;] to start recording.
CD play and recording start at the same time.
The cassette stops when the CD finishes.
The cassette stops when the CD finishes.
To
Operations
stop play
Press [
∫ TAPE/CD].
start one touch play*
Press [
1TAPE] when a cassette is
loaded.
fast-forward
Press [
5/+/FF]. On remote
control, press [
5/FF].
rewind
Press [REW/–/
6].
On remote control, press
[
[
6/REW].
R E W
TAPE
⁄ CD
VOLUME
A
B
Present state
Present time
Tape counter
#
#
]
n
==========
]
n ,
=====
A
B
C
A
D
RX-ES29-ad.book 10 ページ ２００５年３月２３日 水曜日 午後５時４７分