Panasonic ICX 手册
Built-In ACD Supervisor Guide
Section 521
ICX-35-521 (ACD 3.0)
ICX (International) issued March 1999
5
Configuration
The Built-In ACD system is composed of the two circuit cards; the ACD
card and the VPU4 card. These cards are installed into the DBS 576 System.
card and the VPU4 card. These cards are installed into the DBS 576 System.
The system configuration is shown below. Using an RS-232C port allows
MIS (Management Information System) reports to be output to a printer or
PC but not to the both simultaneously.
MIS (Management Information System) reports to be output to a printer or
PC but not to the both simultaneously.
The ICX System can be configured for a maximum of 576 ports can support a
maximum of two Built-In ACD systems. Note that a single-shelf (96-port)
configuration can accommodate only one ACD system.
maximum of two Built-In ACD systems. Note that a single-shelf (96-port)
configuration can accommodate only one ACD system.
Figure 1. ACD Configuration (96 port cabinet shown)
Note: Standard RS232C cables cannot be used for connection. Use the
special cable included with the ACD card. For PC/printer connecting
conditions, see the ACD installation section.
special cable included with the ACD card. For PC/printer connecting
conditions, see the ACD installation section.