Matrox DX002DWLS9OR Fiber Optic Cable 规格指南

Optical Cable Corporation reserves the right to change this specification without prior notification.

•  Indoor/outdoor tight-bound tight-buffered design allows cables to be installed
 in intra-building backbone and inter-building campus locations without costly
 transitions between cable types
•   Ideal configuration for a single termination point requiring multiple fibers

•  High performance components
  and construction
•  Cable materials are indoor/outdoor –
 UL-listed OFNR and UV,
 water and fungus resistant
•  UL Listed in accordance
 with NEC section 770.179(b)

 for use in vertical runs in building  

 riser shafts or from floor to floor
•  Wide operating temperature range
 of -40°C to +85°C
•  Helically stranded core for greater flexibility

 and mechanical protection of the optical fibers
•  High strength-to-weight ratio
•  2-144 fiber configuration is smaller and lighter
 than comparable sub-grouped cables, which is
 ideal for installation in areas with limited
 space or tight bends
•  Can be armored for additional protection in direct burial and aerial installations
•  Interlocking armor can be applied to cables as an alternative to conduit installation

•  900 µm buffer eliminates the need for costly and time-consuming installation of
 fanout kits or pigtail splices because connectors terminate directly to the fiber.  

 See page PI-4 for typical termination approach.
•  No need to splice outdoor cable to indoor cable at building entrance
•  High crush resistance may eliminate the need for innerduct

Operating Temperature

-40°C to +85°C

Storage Temperature

-55°C to +85°C

Installation Temperature (cable temp.)

-10°C to +60°C

Flame Retardancy

UL Listed Type OFNR (UL 1666)  

and FT4 (CSA C22.2 No. 232)

Impact Resistance:

1,500 impacts

Crush Resistance:

1,800 N/cm

Flex Resistance:

2,000 Cycles