Q-Logic Q-Forms Kick Panel Enclosures 业主指南

Ai Research warrants to the original retail purchaser, this product to be free from defective workmanship and material when used under normal conditions in accordance with the product’s
printed instructions for a period of one (1) year from date of purchase.  Ai Research agrees to remedy any such defect or to furnish a new part in exchange for the defective one at no charge for
parts or labor.

This warranty is limited to Ai Research products and specifically excludes consequential damage to other associated equipment which may result for any reason from use with this product.  In no event
shall Ai Research be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set forth above.  Some states do not allow limitations on how
long an implied warranty lasts, and/or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.  This warranty gives you specific
rights and you may also have other rights which vary from state to state.

This warranty does not cover the following:

• Damages caused by water, neglect, abuse, misuse, improper installation or operation.
• Damages caused by acts of God or nature.
• Damages occurring during shipment of the product to Ai Research for repairs.
• Any product which is modified without consent of Ai Research.

• Remove threshold plate by removing attachment screws.
• Pull kick panel away from bulkhead to release mounting clips.
• Make sure all mounting clips are removed.
• Tilt bottom front edge upward and pull kick panel out of vehicle.

• Using two crescent wrenches, carefully bend brake pedal arm so that
   pedal pad is relocated approximately 1.5 inches to the right.

• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the

  vehicle.

• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of

speaker mounting surface.  A die grinder or keyhole saw may also be used.

• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel and into

mounting surface. Be careful to center speakers in mounting surface to allow clearance

for grill

shell.

• Install tweeters as per manufacturer’s instructions.

• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original
   kick panel. Be sure front edge of panel  fits tightly against rubber door seal.
• Reinstall threshold plate using original screws. It may be helpful to hold panel

tightly against rubber door seal while tightening front screw.

• Install long screw and spacer through hole at rear of panel and drive into

inner bulkhead sheetmetal. It may be helpful to predrill screw pilot hole if

installed without power tools.

• Install grill shells by pressing snugly into woofer cavity.

(2)  1.5" plastic spacers
(2)  2" screws
(2)  6" x 8" polyfill pieces
(2)  6.25" Q-grills

inst ver 8.8