MartinLogan Motion® Vision X 业主指南

17

without needing to enter a password. WPS is not 
a standard feature on all routers, and only one 
wireless device can be set up at a time.

Check your router’s owner’s manual to see if WPS 
is an available feature, or look for a button on your 
router marked with the WPS logo (

). If your router 

does not have WPS, then use the Access Point 
Wireless Setup.

1.  For optimal setup conditions place your soundbar 

next to  your wireless router. The soundbar can 
be moved to its final location after wi-fi setup

2.  Plug in your soundbar and press the Power button.

3. The Wi-Fi Setup and Status button will start 

rapidly blinking for 20 seconds while your 
soundbar boots. If this is the first time your 
new soundbar is plugged in, the Wi-Fi Setup 
and Status button will start pulsing slowly. If 
the soundbar is already configured to connect 
to a wi-fi network, the button will turn solid 
(connected) or blink rapidly (not connected).

4.  For 3 seconds, press the soundbar’s Wireless 

Setup and Status button until you hear a tone. 
The soundbar will display “WF.SETUP” and 
after a few seconds the Wi-Fi Setup and Status 
button will blink twice in continuous intervals 
to indicate WPS mode. At any time you can 
press the Wi-Fi Setup and Status button again 
to cancel the setup mode. 

5  Now push the WPS button (

) on your router.

6.  Once the Wi-Fi Setup and Status button is solid (not 

blinking), this indicates your soundbar is connected 
to the wireless network. This may take up to a 
minute. If, after a minute, the button continues to 
blink rapidly, setup failed and you should try again.

7. Connect your mobile device or PC to the 

same network as your soundbar. Launch the 
DTS Play-Fi

®

 app. Upon launching, it will 

automatically detect your soundbar and should 
prompt you to name your soundbar. 

CONNECTING TO A WIRED NETWORK
1.  Using an Ethernet cable, connect your soundbar 

to your router.

2.  Plug in your soundbar and press the Power button.

3. The Wi-Fi Setup and Status button will start 

rapidly  blinking for about 20 seconds while 
your soundbar is booting up.

4.  The Wi-Fi Setup and Status button turns off 

when the soundbar is connected via Ethernet. 

5. Connect your mobile device or PC to the 

same network as your soundbar. Launch 
the DTS Play-Fi app. Upon launching, it will 
automatically detect your soundbar and should 
prompt you to name your soundbar.

Note: Future updates to the DTS Play-Fi application 
may change functionality.

1. Launch the DTS Play-Fi app on your mobile 

device or PC (located in the system tray). 

2.  Android and iOS Device Users: Within the 

Play-Fi app, select your music source. You can 
choose from your personal music library, Internet 
Radio, or from select internet music services. PC 
Users: Any audio content from your computer 
can be streamed using Play-Fi.