MartinLogan Motion® Vision X 业主指南

34.

This equipment is a Class II or double insulated electrical appli-

ance. It has been designed in such a way that it does not require

a safety connection to electrical earth.

35.

Danger of explosion if battery is incorrectly replaced. Replace only with the

same or equivalent type.

36.

(The remote control supplied with) This product contains a AAA battery. If the

AAA battery is swallowed, it can cause severe internal burns in just 2 hours

and can lead to death.

37.

Do not handle leaking or damaged AAA batteries.

38.

THIS PRODUCT CONTAINS A AAA BATTERY. IF MISUSED OR ABUSED THIS

CAN RESULT IN:

- Smoke or gas hazard

- Heat hazard

- Fire hazard

- Explosion hazard

WARNING: This product is intended to be operated ONLY from the AC Voltages listed
on the back panel or included power supply of the product. Operation from other voltages

other than those indicated may cause irreversible damage to the product and void the

product warranty. The use of AC Plug Adapters is cautioned because it can allow the

product to be plugged into voltages in which the product was not designed to operate. If

the product is equipped with a detachable power cord, use only the type provided with

your product or by your local distributor and/or retailer. If you are unsure of the correct

operational voltage, please contact your local distributor and/or retailer.

This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-

ing two conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE
STATEMENT: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Approved under the verification provision of FCC Part 15 as a Class B Digital Device.

Any changes or modifications not expressly approved by the grantee of this device

could void the user’s authority to operate the equipment.

RF EXPOSURE WARNING: This equipment must be installed and operated in accor-
dance with provided instructions and the antenna(s) used for this transmitter must be

installed to provide a separation distance of at least 20 cm from all persons and must

not be co-located or operating in conjunction with any other antenna or transmitter. End-

users and installers must be provide with antenna installation instructions and transmitter

operating conditions for satisfying RF exposure compliance.

5GHz RF DEVICE STATEMENT: This device operates in the 5.15–5.25GHz
frequency range and is restricted to indoor use only. Outdoor operations in the 5150–

5250MHz frequency range is prohibited.

CANADA, INDUSTRY CANADA (IC) NOTICES: This Class B digital apparatus
complies with Canadian ICES-003 and RSS-210. Operation is subject to the following

two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired operation

of the device.

RADIO FREQUENCY (RF) EXPOSURE INFORMATION: The radiated out-
put power of the Wireless Device is below the Industry Canada (IC) radio frequency

exposure limits. The Wireless Device should be used in such a manner such that the

potential for human contact during normal operation is minimized. This device has

also been evaluated and shown compliant with the IC RF Exposure limits under mobile

exposure conditions. (antennas are greater than 20cm from a person’s body).

Caution: (i) The device operating in the band 5150–5250 MHz is only for indoor use

to reduce the potential for harmful interference to co-channel mobile satellite systems;

(ii) The maximum antenna gain permitted for devices in the bands 5250–5350 MHz

and 5470–5725 MHz shall comply with the e.i.r.p. limit; and (iii) The maximum

antenna gain permitted for devices in the band 5725–5825 MHz shall comply with

the e.i.r.p. limits specified for point-to-point and non point-to-point operation as

appropriate. (iv) Users should also be advised that high-power radars are allocated

as primary users (i.e. priority users) of the bands 5250–5350 MHz and 5650–5850

MHz and that these radars could cause interference and/or damage to LE-LAN devices.

CE: Hereby, MartinLogan Ltd., declares that this Motion Vision X is in compliance
with the essential requirements and other relevant provisions of:

1995/5/EC – R&TTE

2004/108/EC – EMC

2006/95/EC – LVD

2011/65/EU – ROHS2