NAD C 388 业主指南

Press [d] once or repeatedly until “Source Setup” is highlighted. Press a or 
s to select other Main menu options - Settings and BluOS Setup (available 
if MDC BluOS module is installed).

Navigate through the menu options using the front panel buttons or 

corresponding SR 9 buttons.

1  Press [ENTER] to select a menu item. Use [d/f] to move up or down 

the Menu items. 

2  Repeatedly press [a/s] to scroll through current menu choices, options 

or selections.

3  Press [ENTER] to save the selection, settings or changes done on the 

current menu. After pressing [ENTER] to finalize a selection, use [d/f] 
to move to other menu options/items.

There are two Source Setup menu items – Enabled and Name. At Source 

Setup menu, select the particular Source you want to enable, disable or 

rename.  

One can enable/disable a Source via this option. This is particularly useful 

if only few Sources are used and one directly selects the Source from the 

front panel, bypassing unused sources.

On: Enable selected Source.

Off: Disable selected Source.

A new Name maybe assigned to a Source label. For example, if your BD player 

is attached to “Optical 1”, it is possible to rename “Optical 1” to “BD Player”.

In order to rename the Source label, select “Name” parameter. 

1  While at the selected Source, for example “Optical 1”, press [d/f] to 

pick through the alphanumeric selections. 

2  Press [s] to move to the next character and at the same time save the 

changes done on the current character. The name can be as long as 

fourteen characters.

3  Repeat steps 1 and 2 for each character in sequence.

4  Complete the renaming process by pressing the [ENTER] button again 

to save the new source’s input name. The new Name will be shown in 

the display.

The “Settings” main menu allows you to configure or show the following 

features:

•  Tone Controls

•

Bass

•  Treble

•

Balance

•  Filters •

Pre 

Out/Subwoofer

•  Speaker Channel

•

Dimmer

•  Auto Standby 

•

Auto Sense

•  IR Channel

•

IR Learning Device

•  Firmware Version

•

Firmware Upgrade 

•  MDC Card Upgrade

Tone controls allow the boosting or reduction of particular audio 

frequencies.  The tone control levels, Bass and Treble, can be turned on or 

off. 

On:  Tone control levels are active. At Tone Controls On, Bass and Treble 

control levels are available for configuration.

Off:  Tone controls levels are bypassed.  At Tone Controls Off, Bass 

and Treble control levels become unavailable or turned off from the 

Settings menu.