MartinLogan Cadence 业主指南

wireless routers that allows your soundbar product to
securely and automatically connect without needing to
enter a password. WPS is not a standard feature on
all routers, and only one wireless device can be set
up at a time.

Check your router’s owner’s manual to see if WPS
is an available feature, or look for a button on your
router marked with the WPS logo (

). If your router

does not have WPS, then use the Access Point
Wireless Setup.

1. For optimal setup conditions place your soundbar

next to your wireless router. The soundbar can
be moved to its final location after Wi-Fi setup

2. Plug in your soundbar and press the Power button.

3. The Wi-Fi Status LED will start rapidly blinking for

20 seconds while your soundbar boots. If this is
the first time your new soundbar is plugged in,
the Wi-Fi Status LED will start pulsing slowly. If
the soundbar is already configured to connect
to a Wi-Fi network, the LED will turn solid
(connected) or blink rapidly (not connected).

4. For 3 seconds, press the soundbar’s Wi-Fi

Setup Button until you hear a tone. After a few
seconds the Wi-Fi Status LED will blink twice in
continuous intervals to indicate WPS mode. You
can also choose “Wireless Setup > Push Button
Setup” from the soundbar menu to enter WPS
Setup Mode. At any time you can press the Wi-
Fi Setup button again to cancel the setup mode.

5 Now push the WPS button (

) on your router.

6. Once the Wi-Fi Status LED is solid (not blinking),

this indicates your soundbar is connected to the
wireless network. This may take up to a minute. If,
after a minute, the button continues to blink rapidly,
setup failed and you should try again.

7. Connect your mobile device or PC to the

same network as your soundbar. Launch the
DTS Play-Fi

app. Upon launching, it will

automatically detect your soundbar and should
prompt you to name your soundbar.

CONNECTING TO A WIRED NETWORK
1. Using an Ethernet cable, connect your soundbar

to your router.

2. Plug in your soundbar and press the Power button.

3. The Wi-Fi Status LED will start rapidly blinking

for about 20 seconds while your soundbar is
booting up.

4. The Wi-Fi Status LED turns off when the

soundbar is connected via Ethernet.

5. Connect your mobile device or PC to the same

network as your soundbar. Launch the DTS
Play-Fi app. Upon launching, it will automatically
detect your soundbar and should prompt you to
name your soundbar.

ALTERNATE SETUP WITHOUT PLAY-FI APP
If you do not want to install and use the DTS Play-Fi

app you can still setup the soundbar to work with
iTunes and AirPlay.

Alternate Connection Method:
1. To avoid a delayed wireless set up, place

your soundbar in close proximity to your router
during wireless set up.

2. Plug in your soundbar and press the Power

button. The Wi-Fi Status LED will start rapidly
blinking for about 20 seconds while your
soundbar is booting up. If your soundbar is
not configured to connect to your network,
it will continue to blink. If this is the first time