Exegin Technologies Limited Q53R6 用户手册
52
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2013
8. Using HTML Pages to Configure the Q53
TCP/IP Forms
TCP/IP Forms
Figure 22—TCP/IP Settings Form
Static vs
Dynamic
Addressing
Dynamic
Addressing
The Q53 may be set up to automatically request its TCP/IP parameters over the network
from a DHCP (Dynamic Host Configuration Protocol) server. To enable this feature,
click on the radio button labelled ’Obtain an IP address automatically’. When this feature
is enabled, the DHCP server will provide all TCP/IP configuration data; in this case,
none of the other fields on the TCP/IP Settings form need to be filled in.
from a DHCP (Dynamic Host Configuration Protocol) server. To enable this feature,
click on the radio button labelled ’Obtain an IP address automatically’. When this feature
is enabled, the DHCP server will provide all TCP/IP configuration data; in this case,
none of the other fields on the TCP/IP Settings form need to be filled in.
If static addressing is desired, then click on the radio button labelled ’Use the following
IP address’. For static addressing, the IP address and Subnet mask are required to be
entered. All other parameters are optional, depending upon your installation
requirements.
IP address’. For static addressing, the IP address and Subnet mask are required to be
entered. All other parameters are optional, depending upon your installation
requirements.
Default: Unconfigured (blank) IP address and subnet mask; dynamic addressing
enabled.
enabled.
Default
Gateway
Gateway
If static addressing is used, and the Q53 will be required to communicate to a different
subnet, then the IP address of a default gateway is required in order to route traffic from
the Q53 to devices on remote subnets. You can leave this field blank if you are not
communicating across a router (from one network to another). In most other situations,
you simply enter your router's IP address in the Default Gateway field.
subnet, then the IP address of a default gateway is required in order to route traffic from
the Q53 to devices on remote subnets. You can leave this field blank if you are not
communicating across a router (from one network to another). In most other situations,
you simply enter your router's IP address in the Default Gateway field.
Default: Unconfigured (blank).