Generac Power Systems 0G6020A 用户手册
5
Wireless Display System
11. Plug the other end of the wire harness into the 8-way connec-
tor at the top of the control panel. The plug will only plug in
one way (Figure 5). DO NOT force the plug into the header.
Gently insert the plug until it locks into place.
Figure 5 — Plug Wire Harness into Header J5
12. Route the wire in the channel along the left hand wall along
with the other wires (Figure 6).
Figure 6 — Route Wire
13. Replace the control panel front.
14. Replace the control panel cover.
15. Turn on the 240Vac Utility source voltage.
16. Reconnect the positive battery cable.
17. Replace the 15Amp control panel fuse.
14. Replace the control panel cover.
15. Turn on the 240Vac Utility source voltage.
16. Reconnect the positive battery cable.
17. Replace the 15Amp control panel fuse.
DISPLAY INSTALLATION
For easier installation, the batteries should first be fitted into the
display unit (Figure 7). This will allow you to walk around and
find the best location for the unit while still receiving good signal
strength. Attach the other transceiver to the generator as described
in the previous section.
Figure 7 — Open Display Unit
1. Insert the batteries (Figure 8).
Figure 8 — Insert Batteries
2. Reset the generator control panel by removing the fuse
on the front cover and then replace it. PERFORM STEP 3
IMMEDIATELY AFTER.
3. IMMEDIATELY turn on the generator display, up to one minute
will pass while the generator tries to find it’s display.