One World Technologies Inc. EL2200 用户手册

8 - English

 Do not allow familiarity with this 

product to make you careless. Remember that a 
careless fraction of a second is sufficient to inflict 
serious injury.

 Always remove the battery pack from 

the product and disconnect the AC power cord when 
you are assembling parts, cleaning, or when not in 
use. Removing these energy sources will prevent 
accidental starting that could cause serious personal 
injury.

 The radio/charger is not waterproof. Do 

not submerge in liquid. Failure to heed this warning 
could result in serious personal injury.

NOTICE:

 Always refer to the manual for any 

device recommended for use as an attachment or 
accessory. Proper use of any device, when attached 
to the radio/charger, is the sole responsibility of the 
operator. Improper use may damage the device or 
the product.

 This radio is capable of producing 

sound levels that can be dangerous to long-term 
hearing. Listening to music at high volume for any 
period of time can cause noise-induced hearing loss. 
The higher the volume, the less time required before 
your hearing could be affected.

You may use this product for the purposes listed below:


Listening to AM/FM radio, MP3 players, CD players, 
and other audio devices



Charging 19.2 V battery packs and USB capable 
devices



Streaming audio from BLUETOOTH

®

 enabled devices

For complete charging instructions, refer to 

later in the Operation section.

See Figure 1, page ii.


  Push the VersaTrack brackets into the slots on the 

back of the radio, as shown.



  Slide the brackets up to lock them in place.

See Figure 2, page ii.
It is advisable to write down saved channels before 
replacing the AAA batteries.
There is a 15-second time frame for replacing the AAA 
batteries. If the batteries are not replaced within 15 
seconds, the radio will lose all settings previously stored 
in memory, and they will require reprogramming.
Always use new alkaline batteries for replacement.

 Danger of explosion if battery is 

incorrectly replaced. Replace only with the same or 
equivalent type.



Remove the AC power cord from the cord wrap.



Loosen the screw in the battery door. Remove door 
and set aside.



Install two new AAA batteries according to polarity 
indicators inside the battery compartment.



Replace the battery door and tighten screw to secure.

See Figure 2, page ii.
A switch has been installed in the bottom of the AAA 
battery compartment. The purpose of this switch is to 
disable the radio circuits so that the charging functions 
of the radio/charger can be tested for compliance with 
California Energy Commission requirements for Battery 
Charger systems. If the switch is in the up position, the 
radio/charger will operate normally; if the switch is in the 
down position, the radio circuits will be disabled while the 
charger circuits continue to function normally.
You should not need to operate this switch under normal 
use conditions. However, if you find that the radio is 
not working while the charger seems to work normally, 
confirm that this switch is in the up position.

See Figure 3, page ii.


Place the battery pack in the radio/charger, aligning the 
rib on the battery pack with the groove in the battery 
port.



Make sure the latches on the battery pack snap into 
place and the battery pack is secured to the radio 
before beginning operation.



Depress the latches to remove the battery pack.

See Figure 4, page ii.
The AC power cord can connect the radio/charger to a 
power supply when a battery is not available or when a 
battery has a low charge. The power cord has a pass-
through plug which allows you to connect the radio/
charger and another device to the same outlet.