One World Technologies Inc. P746 用户手册

6 - English

Do not allow familiarity with this product to make you 
careless. Remember that a careless fraction of a second 
is sufficient to inflict serious injury.

Always remove the battery pack from the product and 
disconnect from the power supply when you are assem-
bling parts, cleaning, or when not in use. Removing bat-
tery pack or unplugging extension cord will prevent acci-
dental starting that could cause serious personal injury.

Always refer to the manual for any device recommended 
for use as an attachment or accessory. Proper use of any 
device, when attached to the radio, is the sole respon-
sibility of the operator. Improper use may damage the 
device or the product.

This radio is capable of producing sound levels that can 
be dangerous to long-term hearing. Listening to music 
at high volume for any period of time can cause noise-
induced hearing loss. The higher the volume, the less time 
required before your hearing could be affected.

You may use this product for the following purposes:


Listening to FM/AM radio, MP3 players, CD players, and 
other audio devices; charging USB-capable devices.

See Figure 1, page 11.
It is advisable to write down saved channels before replacing 
the AAA batteries.
There is a 15-second time frame for replacing the AAA bat-
teries. If the batteries are not replaced within 15 seconds, 
the stereo will lose all settings previously stored in memory, 
and they will require reprogramming.
Always use new alkaline batteries for replacement.


  Loosen the screw in the battery door. Remove door and 

set aside.



  Install two new AAA batteries according to polarity indica-

tors inside the battery compartment.

See Figure 2, page 11.
To install battery pack:


  Place the battery pack in the stereo, aligning the rib on 

the battery pack with the groove in the stereo’s battery 
port.



  Make sure the latches on the battery pack snap into 

place and the battery pack is secured to the stereo before 
beginning operation.

NOTE: Leaving the battery pack connected for long periods 
of time may drain the battery pack. Always disconnect bat-
tery packs after use.
To remove battery pack:


  Depress the latches on both sides to release the battery 

pack from the stereo.

 

NOTE: Always remove battery pack from stereo when 
not in use.

NOTE: The battery pack should be recharged after approxi-
mately five hours of use to reduce the possibility of damage. 
Repeated deep discharge of the battery may decrease stor-
age capacity and battery life.

See Figure 3, page 12.
  Push the 

ON/OFF button to turn the stereo OFF.



  Depress the latches on both sides to release the battery 

pack from the stereo.



  Insert the female end of the power cord into the product 

as shown.



  Connect the male end of the power cord to the power 

source.



  Make sure the power cord is secured before beginning 

operation.

See Figure 4, page 12.
NOTE: The illustrations of the LCD display shown in this 
manual are only examples of the frequencies you may see 
on your stereo and are not the exact frequencies that you 
may choose to listen to.
When the stereo is not connected to a power supply, the 
LCD display will remain off. If the stereo is connected to a 
power supply and in the 

ON position, LEDs will light the 

display. You can view the time, frequency, and settings in 
use on the LCD display.
NOTE: Always disconnect battery packs after use to prevent 
draining the battery pack.