Dickson/Unigage 62831853 用户手册
11
(1) NOTE: Email/Text addresses must first be setup in TOOLS /
EMAIL TEXT ADMIN in order to show in dropdown box. May be
added to Logger after Logger has been setup. Go to Text/Email
Setup section in this manual for instructions.
added to Logger after Logger has been setup. Go to Text/Email
Setup section in this manual for instructions.
xiv) Alarm Temp/Humidity: Set min and max alarm conditions for Logger
if desired.
xv) Alarm Delay: If desired an alarm delay of up to 999 minutes can be
set.
g) Once screen is complete click on SAVE CHANGES AND START button.
A window will pop up “Adding Logger”.
h) DO NOT disconnect Logger until the Info window opens indicating that the
Logger was installed successfully. This may take up to a minute
depending on the PC.
depending on the PC.
i) The Logger now shows up in the WiZARD2 Logger table and can be
placed at the desired logging location. A Signal Sensor is recommended
for proper location of Loggers and Repeaters. See Signal Sensor.
for proper location of Loggers and Repeaters. See Signal Sensor.
j) NOTES:
i) Keep the Logger at the desk until all Loggers and Repeaters have
been added. Plug in AC adapter to Logger (Models WT240 & WH245
only)
only)
ii) DO NOT turn off the Logger when moving it to the target location.
If using a WT240 or WH245, allow the Logger to run on battery power
while moving. Turning off the Logger can cause it to loose time. If the
Logger was turned off for any reason
while moving. Turning off the Logger can cause it to loose time. If the
Logger was turned off for any reason
– including changing batteries,
clear the Logger via USB or Wirelessly to reset time.
iii) The Push-to-Start button can be used to force a transmission if
confirmation of logger connection is necessary. Hold down the button
for 3 seconds to send a transmission.
for 3 seconds to send a transmission.