NIDEC SANKYO CORPORATION 0M0013001A 用户手册

 

 
10. Notes 

  10.1 Note1.  Normal Conditions 

Temperature  20 degrees C 

± 5 degrees C 

Humidity      35%~60% RH 
Mounting     Horizontal (Mounting plate on horizontal surface) 

 

  10.2 Note2. 

Details of specific evaluation method for each characteristic are described in this document, 

and details of quality assurance program are negotiated under separate agreement. 

 

  10.3 Note3. 

For location of the sensors, refer to the appearance drawing. 

 

  10.4 Note4. 

Galvanized steel plate used in this product may show rust at its cut edges but will not interfere the functions. 

 

  10.5 Note5. 

Please do not install SCT the place where temperature suddenly changes. 
Ex.) The place that condensing. The neighborhood of the heater. The place where gets direct rays of the 

sun. etc. 

 
  10.6 Note6. 

Please connect FG of SCT to host FG or earth ground by all means. 

 

10.7 Note7. 

Please stop use in the environment that picks up the noise from the outside. 
There is a possibility to influence the communication. 
 

10.8 Note8. 

With a planned Contactless IC card to use, please examine it enough. 
 

10.9 Note9. 

Our company cannot guarantee the characteristic change of the Contactless IC cards. 

Ex.) Trouble of IC, Heat 
 

10.10 Note10. 

About the FCC declaration of conformity 
 FCC WARNING 

Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment. 

 NOTICE 
    This equipment has been tested and found to comply with the limits for a Class B digital device, 
    pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
    against harmful interference in a residential installation. 
    This equipment generates, uses and can radiate radio frequency energy and, if not installed and 
    used in accordance with the instructions, may cause harmful interference to radio communications.